¿Aun no te has registrado?

Es gratis, se tardan 20 segundos y así podrás usar el foro al 100%

Registrarse

Cambio de aceite

Avatar de Usuario
Lombar
Mensajes: 150
Registrado: Sab Dic 04, 2010 4:33 pm
Vehículos: Dodge Nitro CRD SXT
Ciudad y Pais: Laxe, Spain

Re: Cambio de aceite

Mensaje por Lombar »

La caja de cambios automática del Dodge Nitro CRD es la NAG1 de origen Mercedes Benz. Los gasolina llevan la 42RLE.
Dado que la tienes sin aceite, o con poco, aprovecha y abre la tapa inferior y cambia el filtro. Y limpia bien la tapa y sus lodos. El filtro es muy barato y el trabajo mínimo.
El problema cuando rellenas es que necesitas una varilla especial que lleva en la punta unas medidas. Hay que poner el coche en marcha, que se caliente el cambio, y con un diagnóstico ODB mirar la temperatura del cambio. Dependiendo de la temperatura el líquido hidraúlico tenfrá una altura u otra. Es un proceso que se ha de hacer de una manera muy determinada.
Si solo cambias el aceite del carter y el filtro necesitarás 5 litros. Si vacías todo el kíquido, incluido el convertidor de par y el radiador, necesitarás 7.7 litros.

Es fácil de entender o utiliza Google para la traducción:

CHECK OIL LEVEL

1. Verify that the vehicle is parked on a level surface.
2. Remove the dipstick tube cap.
WARNING: There is a risk of accident from vehicle starting off by itself when engine running. There is a risk of injury from contusions and burns if you insert your hands into the engine when it is started or when it is running. Secure vehicle to prevent it from moving off by itself. Wear properly fastened and close-fitting work clothes. Do not touch hot or rotating parts.
3. Actuate the service brake. Start engine and let it run at idle speed in selector lever position "P".
4. Shift through the transmission modes several times with the vehicle stationary and the engine idling
5. Warm up the transmission, wait at least 2 minutes and check the oil level with the engine running. Push the Oil Dipstick 9336 into transmission fill tube until the dipstick tip contacts the oil pan and pull out again, read off oil level, repeat if necessary.
NOTE: The dipstick will protrude from the fill tube when installed.

Imagen

NAG1 Transmission Fill Graph

6. Check transmission oil temperature using the appropriate scan tool.
NOTE: The true transmission oil temperature can only be read by a scan tool in REVERSE or any forward gear position.
7. The transmission Oil Dipstick 9336 has indicator marks every 10mm. Determine the height of the oil level on the dipstick and using the height, the transmission temperature, and the Transmission Fluid Graph, determine if the transmission oil level is correct.
8. Add or remove oil as necessary and recheck the oil level.
9. Once the oil level is correct, install the dipstick tube cap.


La varilla de medida es como la que se utiliza en los Mercedes, al fín y al cabo es un cambio de esa marca
wgehren
Mensajes: 12
Registrado: Mar Jun 02, 2015 4:01 am
Vehículos: Dodge nitro diesel
Ciudad y Pais: Punta arenas chile

Re: Cambio de aceite

Mensaje por wgehren »

Ok, quiero cambiarlo todo, entonces compro 7.7 litros, el numero del filtro lo tiene? Asi compro todo altiro antes de desarmar. Muchas gracias por la informacion.
Avatar de Usuario
Lombar
Mensajes: 150
Registrado: Sab Dic 04, 2010 4:33 pm
Vehículos: Dodge Nitro CRD SXT
Ciudad y Pais: Laxe, Spain

Re: Cambio de aceite

Mensaje por Lombar »

Si vas a vaciarlo entero son 7.7 litros, pero no salen quitando la tapa donde va el filtro, por ahí solo salen 5 litros. No sé como es el proceso ni tengo el código del filtro ni de la junta. Yo al mío le cambié a los 100.000 líquido y filtro pero lo hice en el concesionario oficial porque estaba aún en garantía, y la verdad es que el precio fué razonable. Pero ahora que son FIAT no sé si sabrían hacerlo ni cuanto cobrarían.
Responder

Volver a “Mecánica Dodge Nitro”